Installing and tightening the sub-frame screws

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Sub-Frame And Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the screws for the support bracket, both sides.

First tighten the screws on the left-hand side of the frame, followed by the right-hand side, to 105 Nm + 120° . Use a bevel protractor 9512050 .

Then tighten the screws for the frame brackets. Tighten to 50 Nm .