Removing lifting beams and the lifting hook

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Gear-Shift Position Sensor

Courtesy of VOLVO CARS OF NORTH AMERICA.

Twist in the tab on the cable harness holder.

Install the screw for the gear-shift position sensor / retainer. Tighten to 25 Nm .

Install the lever on the gear shift linkage rod. Tighten the nut. Tighten to 16 Nm .