Removing the tools

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Clutch Assembly

Courtesy of VOLVO CARS OF NORTH AMERICA.

Screw out the center screw. Remove the compression tool.

NOTE: Applies only to certain engine versions with self adjusting clutches: Keep fingers away from the three clutch rivets when relieving a load or removing the compression tool. There is a risk of clamping injuries.

Applies to all clutch versions:

Remove the hooks. Remove the counterhold.

Remove the centering cone from the clutch driven plate.

Remove the socket. Tap the centering tool lightly with a rubber mallet so that the expander releases. Use a rubber mallet so that the threads are not damaged. Remove the centering tool.

Remove the flywheel gear sector.

NOTE: Installing the transmission: To install the transmission, refer to the car model and year.