Fitting the propeller shaft and driver

WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Propeller Shaft And Special Tool (Holder) 9995561

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fit the propeller shaft to the driver.

NOTE:

Fit the propeller shaft as marked earlier. Refit the bolts in their original positions.

Check the contact surfaces of the viscous coupling and propeller shaft drivers are clean.

Tighten opposite bolts to 8 Nm . Then tighten opposite bolts to 30 Nm . Use holder 9995561

Start by tightening the same bolt both times.