Installing the engine control module (ECM)
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
- Check that no pins or sockets are damaged on the connector.
- Carefully press the control module down into the grooves on the inside of the control module box. Press to the limit position.
- Insert tool 9995722 around the control module.
- Move the upper section of the tool forwards as far as it will go. Pull up the tool.
- Press the cover into place over the control modules.
- Check that the air ducts are correctly positioned.