Check, cables and components
Check cables between the control module #A4, #A5, #A6, #A18, #A19 and the CD-ROM player terminals 4, 5, 11, 12, 13 for an open-circuit according to Open-circuit, permanent faults , a short-circuit to ground according to Short-circuit to ground, permanent faults , and a short-circuit to supply voltage according to Short-circuit to supply voltage. Permanent faults .
Check that the CD-ROM player connector is connected.
If the cables and connector are OK, try a new CD-ROM player.
Remedy as necessary.
Other information:
- To access/replace the control module, see Replacing the control module, old system .
- To access/replace the CD-ROM player, see Replacing, CD-ROM player .
- To connect the breakout box, see Connecting the breakout box .
- Continue
Refer to Verification