Internal fault: Verification

HINT: After carrying out the repair, check that the fault has been remedied.

Fig 1: Identifying Ignition On Position

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Connectors

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Connecting Control Unit

Courtesy of VOLVO CARS OF NORTH AMERICA.

Ignition off.
Reconnect connectors, reinstall components.
Disconnect the Volvo Scan Tool (ST) from the VIDA station. Use it in stand alone mode and connect it to the data link connector (DLC) in the car.
Ignition on.
Use the System test function to test the control module memory. For more information about the System test, see System Test .
Check that the control module memory is OK or not.

If memory functions OK is displayed.

Fig 4: Identifying Scan Tool
Courtesy of VOLVO CARS OF NORTH AMERICA.

Is control module memory OK?