Section 144 (Gear Shift Position Sensor, Solenoid Control System - Removal & Installation (Coupe))
WARNING: This page is about a different car, the 2002 Volvo C70, 2001 Volvo C70, 2000 Volvo C70, 1999 Volvo C70, and 1998 Volvo C70. However, it is still accessible from the selected car via links, so may be relevant.
- Gear Shift Position Sensor
- Gear-Shift Position Sensor (For AW50-42 1999-), Replacing
- Preparations
- Remove the air cleaner (ACL) housing
- Remove the transmission cable from the bracket and the lever from the transmission
- Remove the gear-shift position sensor
- Remove the connector from the transmission
- Separate the connector on the transmission
- Detach the socket for the gear-shift position sensor
- Assemble the connector
- Connect the connector to the transmission
- Install the gear-shift position sensor
- Adjust the Gear-Shift Position Sensor
- Continued gear-shift position sensor installation
- Install the transmission cable on the transmission
- Install the air cleaner (ACL) housing
- Checking diagnostic trouble codes (DTCs)
- Gear-Shift Position Sensor (For AW55-50 and AW50AWD 2000-), Replacing
- Notes
- Replacing the gear-shift position sensor
- Removing the gear-shift position sensor for the V70 2000
- Removing engine compartment components
- Removing the transmission cable
- Removing the gear-shift position sensor
- Removing the connector from the transmission
- Disassembling the connector on the transmission
- Assembling the connector
- Installing the connector on the transmission
- Installing the gear-shift position sensor
- Adjusting the gear-shift position sensor
- Installing the gear-shift position sensor, continued
- Installing the gear selector cable
- Installing engine compartment components
- Checking diagnostic trouble codes (DTCs)
- Removing the gear-shift position sensor for the V70 2001
- Installing the gear-shift position sensor
- Adjusting the Gear-Shift Position Sensor
- Installing the Lever And the Gear-Shift Position Sensor
- Installing engine compartment components
- Checking diagnostic trouble codes (DTCs)
- Gear-Shift Position Sensor (For AW55-50 and AW50AWD (AMB) 1999-), Replacing
- Gear-Shift Position Sensor (For AW55-50 and AW50AWD 2001-), Replacing
- Gear-Shift Position Sensor (For TF-80SCAWD D5244TX 2006-), Replacing
- Gear-Shift Position Sensor (For TF-80SC D5244TX 2006-), Replacing
- Gear-Shift Position Sensor (For AW50-42 1999-), Replacing
- Oil Change Counter
- Seals & Splines
- Pinion Seal for Bevel Gear, Replacing
- Seal CV Joint Housing, Replacing
- Splines, Greasing
- Solenoid Control System
- Solenoid Control System, Replacing (For AW55-50 And AW50AWD 2001-)
- Solenoid Control System, Replacing (For AW50AWD 2003-)
- Solenoid Control System, Replacing (For TF-80SC D5244TX 2006-)
- Solenoids, Control System, Replacing (For AW50-42 1999)
- Notes
- Removal
- Preparations
- Remove the terminal from the transmission
- Install the lifting beam and lifting hook
- Raise the car
- Removing the Right-Hand Drive Shaft
- Remove the screws for the cable conduit and the ground lead bracket on the sub-frame
- Remove the Ball Joint Nuts (Both Sides)
- Remove the Bracket For the Power Supply Cable To the Heated Oxygen Sensor (HO2S) from the Sub-Frame
- Remove the collision protection system over the steering gear (Only right-hand drive cars)
- Disconnect the steering gear from the sub-frame
- Remove the Screws For the Sub-Frame Support Brakes, Both Sides
- Lower the sub-frame
- Drain the transmission oil
- Remove the control system cover
- Checking the solenoids
- Information, versions and combinations
- Reinstall the control system
- Assembling the control system
- Installing the sub-frame and front suspension components
- Reinstall the sub-frame
- Install the steering gear/sub-frame components
- Install the nuts for the Ball Joint/Control Arm And Anti-Roll Bar/Link Rod
- Install the collision protection system over the steering gear (right-hand drive cars)
- Install the heated oxygen sensor (HO2S) bracket
- Install the drive shaft screw
- Install the splashguard under the engine
- Remove the lifting beams and lifting hook
- Solenoids, Control System, Replacing (For AW55-50 2000)
- Test Drive