Installing and tightening front suspension components
Install a new M12 lock nut for the ball joint pinion. Counterhold the ball joint pinion while tightening so that the ball joint boot cannot turn. Tighten. See: Summary of tightening torques for specific components
Tighten the drive shaft screw. Counterhold using a screwdriver in the brake disc vents. Tighten. See: Summary of tightening torques for specific components .
Use: 9512050
Install:
- the link for the anti-roll bar. Use a new M10 lock nut. Counterhold the ball joint pinion while tightening so that the ball joint boot cannot turn. Tighten. See: Summary of tightening torques for specific components
- the tie rod. Tighten. See: Summary of tightening torques for specific components
- The ABS line in the mounting in the spring strut
- the wing liner with support plate and nuts.
Checking and topping up oil
Check and top up with oil. See: Transmission Fluid, Replacing .