Removing the tools

Fig 1: Identifying Clutch Assembly

Courtesy of VOLVO CARS OF NORTH AMERICA.

Screw out the center screw. Remove the compression tool.

NOTE:

Applies only to certain engine versions with self adjusting clutches: Keep fingers away from the three clutch rivets when relieving a load or removing the compression tool. There is a risk of clamping injuries.

Applies to all clutch versions:

Remove the hooks. Remove the counterhold.

Remove the centering cone from the clutch driven plate.

Remove the socket. Tap the centering tool lightly with a rubber mallet so that the expander releases. Use a rubber mallet so that the threads are not damaged. Remove the centering tool.

Remove the flywheel gear sector. Check the flywheel. See Flywheel, Checking .

NOTE:

To install the transmission, see Transmission, Installation .