Installing the seat rail, left hand side

Fig 1: Rail On Bracket/Cross Member And Two Screws For Front-Rear Adjustment Motor

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the rail on the bracket / cross member
two plus one screws
the two screws for the front-rear adjustment motor.

Install the end mounting. See Seat belt buckle end mounting

Install the seat. See Removing power seats, tilting .

NOTE:

Removed seat rails must always be checked for movement. Use Vernier calipers to measure from the fixed to the moving component. Both rails should have the same measurement. If not, adjust one of the rails. If the rails do not have the same measurements the seat does not run parallel. This leads to increased wear and noise.