Installing the Water Pump And Rubber Cap

Fig 1: Identifying Foam Taped To Water Pump Protrusion

Courtesy of VOLVO CARS OF NORTH AMERICA.

Thread the new water pump into the existing rubber mounting using the marking made earlier.

Wind foam tape from the kit around the section of the water pump protruding from the rubber mounting.

Fig 2: Identifying Water Pump, Connector & Rubber Cap

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the water pump and rubber mounting on the screws for the engine block heater.

Route the water pump wiring as illustrated.

Connect the connector to the top of the water pump.

Thread the rubber cap from the kit over the cable harness and the upper section of the water pump.

Secure the rubber cap. Use the tie strap from the kit.