Receiver Drier, Replacing: Installation
NOTE:
For tightening torques, see: Tightening torque
.
Installing the drier filter
NOTE:
Always plug the pipes and connections when working on the climate control system.
NOTE:
Use new O-rings lubricated with compressor oil.
Install:
- the dryer filter with the screw, 1 pc., from underneath acc. to Summary Of Tightening Torques For Specific Components
- screw by the service valve, 1 pc. and tighten acc. to Summary Of Tightening Torques For Specific Components
- the condenser, see Condenser, Replacing .
NOTE:
For tightening torques, see: Tightening Torque
.
Installing the drier filter
NOTE:
Always plug the pipes and connections when working on the climate control system.
NOTE:
Use new O-rings lubricated with compressor oil.
Install:
- the drier filter with the screw, 1 x M8, from below and tighten
- screw by the service valve, 1 pc. and tighten.
- the condenser, see: Condenser, Replacing .
NOTE:
For tightening torques, see Tightening Torque
.
Installing the drier filter
NOTE:
Always plug the pipes and connections when working on the climate control system.
NOTE:
Use new O-rings lubricated with compressor oil.
Install:
- the dryer filter with the screw, 1 pc., from underneath acc. to Summary Of Tightening Torques For Specific Components
- screw by the service valve, 1 pc. and tighten acc. to Summary Of Tightening Torques For Specific Components
- the condenser, see Condenser, Replacing .