Installing the propeller shaft
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Install the propeller shaft using the marking made earlier. See Removing the propeller shaft .
Check carefully that the mating surfaces on the propeller shaft and flange are clean.
Use new screws when installing the propeller shaft. First tighten the screws that are opposite each other. See Summary of tightening torques for specific components . Then tighten all screws crosswise. See Summary of tightening torques for specific components . Use counterhold 9995743 .
Install:
- the support for the center bearing on the car body. Tighten
- the screws for the center bearing on the propeller shaft. Tighten.