Removing the propeller shaft

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Screws From Joint Using Counterhold (999 5743)

Courtesy of VOLVO CARS OF NORTH AMERICA.

Mark the position of the joint on the flange.

Remove the screws from the joint. Use counterhold 9995743 .

Leave one screw in place by a few threads for safety.

Fig 2: Identifying Rear Propeller Shaft (Rear Exhaust System Section Removed)

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the screws from the support for the propeller shaft center bearing.

Slacken off the screws in the support for the center bearing on the right-hand side a few turns. Fully remove the screws on the left-hand side.

Let the member hang down so that the propeller shaft can be angled.

Remove the screw from the joint.

Press the shaft joints together. Remove the shaft from the carrier plate. Move the shaft to one side.

Tie up the shaft.