Installing trailing arms and track rods (both sides)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Raise the wheel bearing housing so that the hole for the trailing arm in the bearing housing and rear axle member is horizontal.
Install the trailing arm. Use new screws, M12. Tighten.
Install the tie rod on the wheel bearing housing. Use new lock nuts, M12. Tighten. Install the parking brake cable in the holder on the tie rod and in the cable mountings in the lower cover. Tighten. See Summary of tightening torques for specific components .