Installing the control system
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Ensure the lever for the gear selector is set to neutral.
Align the control system lever with the gear selector lever.
Install:
- the screws for the control system
NOTE:
The different screw lengths are given in mm. See the illustration.
- a new gasket for the cover on the control system.
Tighten the screws alternately to light contact. Then tighten to:Summary of tightening torques for specific components .
Install:
- the new cable harness. Connect the connectors to the solenoids
- the oil temperature sensor with the holder and screw. Tighten. See: Summary of tightening torques for specific components
NOTE:
Screw length given in mm as illustrated.
Install the cable harness on the holder. Check that the cable harness is correctly positioned.