Installing the cable harness and transmission cables.

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Applies only to model year 2000.

Fig 1: Identifying Gear-Shift Position Sensor

Courtesy of VOLVO CARS OF NORTH AMERICA.

Turn in the tab on the cable harness holder.

Install the screw for the gear shift position sensor/holder. Tighten. See: Summary of tightening torques for specific components .

Install the lever on the gear shift linkage rod. Tighten the nut. See: Summary of tightening torques for specific components .

NOTE:

Applies only to model year 2001.

Fig 1: Locating Gear-Shift Position Sensor Screw And Gear Shift Linkage Rod

Courtesy of VOLVO CARS OF NORTH AMERICA.

Turn in the tab on the cable harness holder.

Install:

the screw for the gear shift position sensor holder. Tighten. See: Summary of tightening torques for specific components
the lever for the gear shift linkage rod. Tighten the nut. See: Summary of tightening torques for specific components .