Removing the propeller shaft, front
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Only mark the position of the propeller shaft CV joint in relation to the bevel gear's flange if the same bevel gear is to be reused.
Remove the screws from the propeller shaft. Use counterhold 9995743
Press the drive shaft joints together as much as possible.
Remove the screws on left-hand side from the support for the center bearing.
Remove the shaft from the bevel gear and angle it as much as possible.
Leave the end of the shaft resting against the anti-roll bar.
NOTE:
Be careful. Do not damage the heated oxygen sensor (HO2S) or its cable.