Installing a new sealing ring

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Installing New Sealing Ring

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the new sealing ring for the drive shaft.

Lubricate the seal using wheel bearing grease, P/N 1161241-3.

Use drift 9997401 . Tap in the ring to stop.

If also replacing the seal for the crown wheel shaft, proceed to Sealing ring for crown wheel shaft for bevel gear, replacing .

NOTE:

To install drive shaft, see.