Installing the sealing ring

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Sleeve 7087-1 Installed In End Of Shaft

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install sleeve 7087-1 in the end of the shaft. Lubricate the lip of the new sealing ring. Use grease 116 1241-3 (80g). Position the seal on the sleeve.

Fig 2: Installing The Seal Into The Bevel Gear Using Drift 999 7087 Together With Spacer Ring 7086-1

Courtesy of VOLVO CARS OF NORTH AMERICA.

Knock the seal into the bevel gear. Use drift 9997087 together with spacer ring 7086-1. Ensure that the tool goes towards the bevel gear housing. Check that sleeve 7087-1 is removed with the tool.