Installing the propeller shaft

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Propeller Shaft And Exhaust Secured Using Strap

Courtesy of VOLVO CARS OF NORTH AMERICA.

Check that the mating surfaces on the propeller shaft CV joint and flange are clean.

Align the propeller shaft CV joint against the flange.

Install the screws loosely in the support for the center bearing and the propeller shaft.

Fig 2: Identifying Front Propeller Shaft And Special Tool 999 7057

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install the propeller shaft using the marking made earlier.

Tightening the propeller shaft CV joint

Use new screws.

First tighten the screws crosswise. Tighten to 8 Nm . Then tighten to 30 Nm .

Use counterhold 9997057 .

Tighten the screws for the support for the center bearing. Tighten to 25 Nm .

Tighten the screws for the propeller shaft center bearing. Tighten to 25 Nm .