Installing the bevel gear
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Check that there is no oil leakage between the bevel gear, s connecting sleeve and the sealing ring on the transmission, and that the sleeve is not generally damaged and is seated correctly.
To replace the connecting sleeve and seal, see: Seal rings, connecting socket .
Make sure that the contact faces on the transmission and bevel gear are clean.
Install the bevel gear. Use new screws. Tighten the screws alternately to light contact. Tightening torque .