Lowering the sub-frame at the rear edge

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Rear Sub-Frame Screws, Brackets & Washers

Courtesy of VOLVO CARS OF NORTH AMERICA.

Place a mobile jack with a universal fixture 9995972 at the rear of the subframe.

Remove the screws holding the sub-frame brackets to the bodywork on both sides.

Remove the rear sub-frame screws together with the brackets and washers.

Unscrew the front screws in the sub-frame by 10-15 mm.

Fig 2: Bracket For Heated Oxygen Sensor (HO2S) From Mounting

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the bracket for the heated oxygen sensor (HO2S) from its mounting (6 cylinder engines only).

Lower the rear edge of the sub-frame approximately 90 mm. Ensure that the steering gear screws are released from the sub-frame.

Remove the mobile jack.