Installing the pressure hose

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Screw, Lock Bracket & Pipe Coupling Area At Power Steering Pump

Courtesy of VOLVO CARS OF NORTH AMERICA.

Tighten the screw clip on the sub-frame. Tighten to 10 Nm .

Install:

the pipe nipple in the pump. Tighten to 25 Nm
the lock bracket (2).

Tighten the screw (1). Tighten to 24 Nm .

NOTE: There may be a gap (3) of a few millimeters between the pipe coupling and the power steering pump. Bend the bracket so that the twelve edged mounting on the bracket is on the nut.