Preparations when removing gearbox

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Fender Liner Tied Up To Lifting Beam Using A Retaining Strap

Courtesy of VOLVO CARS OF NORTH AMERICA.

Remove the 2 x nuts from the wing liner. Remove the support plates on both sides.

Applies to the left-hand side only:

Angle out and tie up the wing liner to the lifting beam using a retaining strap.

NOTE:

Do not forget to protect the front fender.