Section 211 (Transmission Sensors - Removal And Installation)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
- Transmission
- Temperature sensor, transmission fluid, replacing
- Transmission input speed sensor, replacing
- Transmission output speed sensor, replacing (AW50-42)
- Transmission output speed sensor, replacing (AW55-50)
- Notes
- Preparations
- Removing the air cleaner (ACL) housing and intake manifold
- Disassembling the connector for the transmission output speed sensor. Removing the sensor
- Lubricating the O ring for the new transmission output speed sensor. Installing the sensor
- Installing the air cleaner (ACL) housing and intake manifold
- Checking diagnostic trouble codes (DTCs)
- Transmission, installation
- Notes
- Cleaning and lubricating the input shaft
- Checking before installing
- Adjusting the position of the transmission and engine
- Installing and tightening screws for the transmission
- Lifting the engine and transmission to the horizontal position
- Installing the rear engine mounting
- Installing the bevel gear
- Installing the front propeller shaft (Applies to AWD)
- Installation of the collision protection above the steering gear (Only applies to right-hand drive vehicles.)
- Fitting the sub-frame to the body
- Installing the sealing ring for the CV joint housing
- Installing the left hand drive shaft to the transmission, wheel spindle and link arm
- Installing new lock nuts and screws on the steering gear
- Installing the screw in the rear engine pad
- Installing screws for the bracket for the heated oxygen sensor (HO2S) wiring
- Installing the crossmembers
- Installing the right-hand drive shaft to the gearbox, wheel spindle and link arm
- Installing the screw for the front engine pad and the torque rod mounting in the transmission
- Installing and tightening front suspension components
- Tightening the ball joint pinion
- Installing the nuts on the fender liner
- Checking the oil level in the transmission
- Installing the screws for the transmission and engine
- Installing the pipe junction
- Installing the bracket and lever for the transmission
- Installing the water hose
- Installing the upper torque rod
- Transmission oil level, checking