Fitting the subframe to the body
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Use new screws. Lubricate the screws' threads.
Applies to certain models.
Raise the subframe so that it remains approx. 150 mm before reaching the side member.
Secure the servo line with the rubber clamp in the front on the top of the frame. Fit the screw loosely.
NOTE:
When the subframe is raised, make sure that the spring strut ball joint pin aligns in the link arm.
Install:
- the new screws and the support bracket at the back
- the bracket screws loosely.
Tighten the subframe screws to light contact.
Remove the mobile jack.