Fitting the remaining screws to the gearbox/starter motor

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Cable Harness Clamp Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the screws, 3 x M10, to the gearbox/engine. Tighten
the screws for the starter motor. Tighten. See: Summary of tightening torques for specific components
the bracket to the coolant hose-cable harness
the bracket to the cable harness clamp and the bracket for the heated oxygen sensor (HO2S) connectors in the rear edge of the gearbox
the clamp to the cable harness at the rear edge of the engine
the bracket for the air cleaner (ACL), 2 x M10. Tighten (Applies only to B5254T4).