Install and tighten the screws for the transmission

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Gearbox Screws

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install all 7 screws for the transmission / engine.

First tighten alternately and crosswise to light contact.

At the same time, check that the whole of the transmission is in contact with the engine.

Then tighten the screws crosswise. Tighten the screws for the transmission and engine. Tighten to 50 Nm . Tighten the screws for the starter motor. Tighten to 40 Nm .

Remove the fixture from the transmission.