1.6 Pin/Pin sockets

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: 1.6 Pin/Pin sockets (1 Of 2)

Courtesy of VOLVO CARS OF NORTH AMERICA.

For housings for 1.6 Pin/pin sockets no terminal removal tool is used.

The cable terminals have no locking tabs. The primary locking is located in the cavities.

Fig 2: Cable Terminal Without Locking Tab

Courtesy of VOLVO CARS OF NORTH AMERICA.

With the secondary locking opened the cable terminals can be extracted from the cable side by pulling the cable.

No terminal removal tool is required.

See Example 1 and Example 2A for the procedure.

Fig 3: Cavity Opening For 1.6 Pin/Pin Sockets

Courtesy of VOLVO CARS OF NORTH AMERICA.

The cavity opening for 1.6 Pin/Pin sockets is the smallest of the round cavity types.

Proceed to chapter New cable terminal Seal SWS and plug . Replacing a cable terminal in order to crimp a new cable terminal.