Checking cables

Check signal cable (+) between control module #A42 and heated oxygen sensor (HO2S) connector terminal 4 for an intermittent short-circuit to ground according to Short-circuit to ground, intermittent faults .

Check signal cable (-) between control module #A41 and heated oxygen sensor (HO2S) connector terminal 3 for an intermittent short-circuit to ground according to Short-circuit to ground, intermittent faults .

Other information 

• To connect the breakout box, see connecting the breakout box
• To access the control module, see Replacing the engine control module (ECM)
• To access/replace the heated oxygen sensor (HO2S), see Heated oxygen sensor (HO2S), replacing
• For information about signals, see Signal specification

Fig 1: Identifying 4-Bit connector

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Continue 

  Refer to Information