Valve clearance: Finishing

Fig 1: Identifying Expansion Tank And Servo Oil Reservoir

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install 

• front timing cover
• the auxiliaries belt
• the expansion tank
• the servo oil reservoir
• the bleed hose for the expansion tank.

  Close the clamp and check that the hoses lie correctly.

Connect the connectors for the 

• The ABS sensor by the right suspension turret
• the coolant level sensor in the expansion tank.

Install 

• the starter motor
• the plastic nuts for the cover in the wing liner
• the right front wheel. See Installing wheels .

Fig 2: Identifying Engine Compartment Components

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install 

• the trigger wheel.
  NOTE:

  Make sure that the trigger wheel is correctly positioned against the camshaft.

• the camshaft position (CMP) sensor housing
• the cover at the rear of the exhaust camshaft
• the screws holding both the ground strips from the bulkhead to the cylinder head
• the upper engine stabilizer brace
• the cover over the ignition coils
• the upper timing cover
• the crankcase ventilation hose on the inlet hose
• the inlet hose between the air cleaner (ACL) and throttle body (TB)
• the engine stabilizer brace between the suspension turrets. Secure the servo hose at the right mounting for the engine stabilizer brace in the bodywork
• the cable to the battery negative terminal. Also read Battery, disconnecting .