Checking valve clearance: Finishing

Fig 1: Identifying Camshaft Covers

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install (common) 

• the plugs for the test holes. Tighten to 20 Nm 
• the ignition coils according to the earlier markings
• the ground connections
• the connector for the variable valve timing solenoid.

Remove tool 9995754 .

Fig 2: Identifying Engine Compartment

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install (naturally aspirated engine) 

• the trigger wheel. Tighten to 17 Nm  .
  NOTE:

  Ensure that the trigger wheel is correctly positioned against the camshaft.

• the camshaft position (CMP) sensor housing
• the cover over the ignition coils
• the upper timing cover
• the crankcase ventilation hose on the inlet hose
• the inlet hose between the air cleaner (ACL) and throttle body (TB)
• the plastic nuts from the cover in the fender liner
• the right front wheel. See Installing wheels .

Install (turbocharged engine) 

• a new cover over the intake camshaft
• secure the cable harness for the injector
• charge air pipe above the engine and holder at the rear of the engine.

Install (common) 

• the plastic nuts from the cover in the fender liner
• the right front wheel. See Installing wheels .