Removing The Clamp From The Inner Boot (If The Boot Is Being Replaced)

Fig 1: Clamp From Inner Gaiter

GLL109786

Courtesy of VOLVO CARS OF NORTH AMERICA.

Cut the boot and remove it from the shaft.

NOTE:

The outer constant velocity joint can be cleaned while assembled. For checking and cleaning see Cleaning / checking the outer constant velocity joint .

NOTE:

The inner constant velocity joint can be cleaned while assembled and blown clean prior to greasing.

To disassemble the joint, see Clean and mark up the constant velocity joint , Separate the shaft and pull out the inner joint and Checking and inspection .

To assemble and lubricate the outer joint:

See Installing the inner ring in the ball holder , Lubricating the constant velocity joint , Replacing the circlip , Installing the new boots on the drive shaft , Greasing the boot and Venting the boot .