Installing the final drive

Fig 1: Positioning Mobile Jack (998 5972) Together With Fixture (999 5972)

Courtesy of VOLVO CARS OF NORTH AMERICA.

Press the final drive up against the rear axle member. Align all screws.

Lightly tighten the screws alternately.

Tighten the 8 screws for the cover. See Summary Of Tightening Torques For Specific Components .

Tighten the M12 screw for the front bushing in the final drive housing.

Remove the jack.

Connect the connector to the wiring harness for the Active on Demand coupling.