Removing the radio/carphone
Remove the dashboard environment panel. See Removing the dashboard environment panel .
Remove the radio/carphone:
Unscrew the two screws in the lower edge.
NOTE:
Reset the CD-mechanism to original position before replacing the unit.
Hold the radio unit in the same position as when installed in the vehicle (tilted 15-20°) as illustrated. See Fig 2.
Reset the CD mechanism by:
- Switch on the ignition.
- Disconnect the green connector from the radio/CD player. Wait 5 seconds
- Reconnect the green connector to the radio/CD player. The CD player has been reset
- Wait until no sound is heard from the CD mechanism.
Remove the cable harness.