Checking components and wiring
Check the signal cable between the combined instrument panel terminal #B22 (#22) and LPG control module terminal #J1/29 (#A29). Check for an open-circuit. Check for a short-circuit to supply voltage.
Check the combined instrument panel connector. Check for contact resistance and oxidation.
Check the bulb in the combined instrument panel.
Remedy as necessary.
Other information:
- To connect the breakout box, see Connecting the breakout box
- For information about signals, see Signal specification
- To access and replace the combined instrument panel, see Driver information module, removing/installing
- To fault-trace wiring and terminals, see Contents
- Continue
Refer to Verification