Checking components and wiring

HINT: The diagnostic trouble code (DTC) is stored if the reset button is pressed in for more than 25 seconds. 

HINT: The voltage between the mode selector terminals #1, #2 and #7 and ground must be 10-12 V when the connector is disconnected and the ignition is on. 

Check the signal cables between mode selector terminals #1, #2 and #7 and the combined instrument panel terminals #A3, #A5 and #A6. Check for a short-circuit to ground.

Remedy as necessary.

Other information: 

• See Checking wiring and terminals. Permanent fault
• To connect the breakout box, see Connecting the breakout box
• To access and replace the combined instrument panel, see Driver information module, removing/installing
• To access or replace the trip computer control panel, see Front door module
• For information about signals, see Signal specification .

Fig 1: Identifying Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ohm Meter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Trip Computer Reset Button

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Continue 

  Refer to Verification