Checking components and wiring

Check the signal cable between combined instrument panel terminal #B8 (#8) and gas level sensor terminal #1. Check for a short-circuit to ground. Also check the cable between the sensor and the connectors.

Remedy as necessary.

Other information: 

• To connect the breakout box, see Connecting the breakout box
• For information about signals, see Signal specification
• To access and replace the combined instrument panel, see Driver information module, removing/installing
• To access and replace the gas level sensor, see Replacing the level sensor
• To fault-trace wiring and terminals see Contents

Fig 1: Identifying Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Fuel Level Sensor

Courtesy of VOLVO CARS OF NORTH AMERICA.

• Continue 

  Refer to Verification