Instrumentation - Removal, Replacement And Installation (Convertible)

• Instrument Panel (1998)
  • Combined instrument panel
    • Precautions for when replacing components
    • Combined instrument panel or connection plate, replacement
      • Notes
      • Read and program combined instrument panel.
    • Replacing bulb
      • Bulbs in the combined instrument panel
      • Removing bulb
      • Installing bulb
    • Replacing cover
      • Removing cover
      • Installing cover
    • Replacing dial face
      • Removing dial face
      • Installing dial face
    • Replacing fuse
      • Removing fuse
      • Installing fuse
    • Replacing heat sink
      • Removing heat sink
      • Installing heat sink
    • Replacing instrument housing
      • Removing instrument housing
      • Installing instrument housing
    • Replacing tachometer, temperature gauge, fuel gauge and speedometer
      • Removing tachometer, temperature gauge, fuel gauge and speedometer
      • Installing tachometer, temperature gauge, fuel gauge and speedometer
• Instrument Panel (1999-2004)
  • Combined instrument panel
    • Replacing cable plate
      • Preparations
      • Removing the cable plate
      • Ordering software
      • Programming the cable plate
      • Installing the cable plate
    • Replacing base plate
      • Removing base plate
      • Installing base plate
    • Replacing bulb
      • Removing bulbs
      • Installing bulb
    • Replacing cover
    • Replacing dial face
    • Replacing heat sink
    • Replacing instrument housing
    • Replacing tachometer, temperature gauge, fuel gauge and speedometer
    • Replacing the driver information control unit
      • Preparation
      • Removal of driver information control unit
      • Installation of driver information control unit
      • Ordering software
      • Programming the control unit
      • Precautions for when replacing the component
    • Bulbs in the combined instrument panel
  • Replacing sensors
    • Notes
    • Brake fluid level sensor
    • Fuel level sensor AWD
    • Fuel level sensor 2WD
      • Notes
      • Removing covers and panels, applies to all 850 variants
      • Separating the connector
      • Removing the fuel level sensor
      • Installation
    • The fuel level sensor is not centered in the body panel
      • Preparations
      • Adjusting the fuel tank
      • Further adjustment
      • Tightening the fuel tank
    • Engine coolant level sensor
    • Oil pressure sensor
    • Handbrake switch
    • Outside temperature sensor
    • Engine coolant temperature (ECT) sensor
    • Replacing level sensor fuel tank
  • Fuel pump unit, replacing
    • Notes
    • Preparation and precautions
    • Removing the rear suspension assembly
    • Fitting the fuel pump units
    • Fitting the rear suspension assembly