Overview - Control Housing

WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Control Housing

Courtesy of AUDI OF AMERICA, LLC

Seal
- Replace
Guide Rail: Clipped to the Control Housing
Control Housing
Camshaft Adjustment Valve 1 -N205-
- Removing and Installing. Refer to CAMSHAFT ADJUSTMENT VALVE 1 Camshaft Adjustment Valve 1 -N205- AND EXHAUST CAMSHAFT ADJUSTMENT VALVE 1 Exhaust Camshaft Adjustment Valve 1 -N318-, REMOVING AND INSTALLING .
Bolt
- 3.8 Nm
Exhaust Camshaft Adjustment Valve 1 -N318-
- Removing and Installing. Refer to CAMSHAFT ADJUSTMENT VALVE 1 Camshaft Adjustment Valve 1 -N205- AND EXHAUST CAMSHAFT ADJUSTMENT VALVE 1 Exhaust Camshaft Adjustment Valve 1 -N318-, REMOVING AND INSTALLING .
8 Nm +90° additional turn
- Always replace after removing

Checking strainer of control housing for contamination

Fig 2: Backside Of Control Housing & Screen

Courtesy of AUDI OF AMERICA, LLC

-- Remove the screen -2- on the back of the control housing -1- and clean off any dirt.