Rear Name Badge, Replacing: Removing
WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The name badge is integrated in the trim molding.
The trim molding cannot be removed from the two-sided adhesive tape without destroying it.
Follow the instructions for installing the trim molding. Refer to Assembly Instructions .
-- Warm the trim molding -1- using a Wiring Harness Repair Set - Hot Air Blower:VAS1978/14A .
-- Remove the trim molding -1- from the rear lid -2- until the adhesive tape -3- is loosened.