Assembly Instructions

WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.

Warm the name badges or emblem before removing using a Wiring Harness Repair Set - Hot Air Blower:VAS 1978/14A .
When a name badge or emblem is removed and installed, use only the Adhesive Remover:D 002 000 10 to remove the adhesive residue.
If necessary, remove any adhesive residue left by the tape using Adhesive Strip Remover:VAS 6349 .
Make sure the adhesive surfaces are free of dust and grease.
Attach the name badges or emblems immediately after cleaning.
Only remove the protective film right before assembly.
The temperature must be approximately 21 °C (69.8 °F).
It is not possible to remove the bonded name badges or emblems without damaging them.