Brake Booster -NX6-, Removing And Installing: Installing
WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Replace the seal between the brake booster and bulkhead.
-- Insert the brake booster and install the nuts hand tight.
-- Refer to Brake Pedal, Attaching to Brake Booster .
-- Install the brake lines with the Torque Wrench - Assembly Tool: VAG1410/8 .
Conditions
- Do not tilt the brake lines when attaching.
-- Tighten the brake booster.
-- Refer to Hydraulic System, Bleeding .
If the Brake Booster Control Module -J539- was Replaced, Then the Test Plan for Replacing the Control Module Must Be Completed.
-- Complete the "Control module, replacing" function with the Vehicle Diagnostic Tester. Refer to Diagnostic Entries .
Continuation