SUBFRAME, Lifting With Scissor Lift Table

WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Scissor Lift Table: VAS 6131B

Removing

-- Refer to SCISSOR LIFT TABLE PREPARING .

-- Position the Scissor Lift Table: VAS 6131 B -A- lengthwise under the vehicle, align it and move it upward.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Position the mounts -2- and -4- as shown on the subframe -1-.

-- Align the mounts -2- and -4- for height.

-- Lift the Scissor Lift Table: VAS 6131B -A- farther upward.

-- Position the mounts -4- to the subframe -1- to the right in the holes.

-- Position the mounts -2- to the subframe -1- to the left in the holes.

-- Tighten the bolts for the mounts -2- and -4- on the Scissor Lift Table: VAS 6131B -A- to 40 Nm.

-- Position the mount -3- to the rear subframe -1- on the crossbrace.

-- Adjust the height of the mounts -2-, -3- and -4- and tighten.

-- Further lift the Scissor Lift Table: VAS 6131B and support the subframe -1-.