Left/Right Front Seat Belt NX10/NX11, Removing And Installing: Installing

WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

If components of the belt system is removed due an accident.

-- Replace all bolts from the belt system. Refer to Overview - Front Three-Point Seat Belt .

Continuation for all vehicles

-- Insert the front seat belt with anti-twist mechanism -1- in -the direction of the arrow- into the mount and tighten the bolt.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Attach the connectors until they click into place.

Continuation

-- Connect the battery ground cable. Refer to BATTERY, DISCONNECTING AND CONNECTING .

CAUTION:

Pyrotechnical components can deploy unintentionally.

Risk of injury.

- Keep as far away as possible from the pyrotechnic component when switching the ignition on.

-- Switch the ignition on.

-- For vehicles with Left Front Seat Belt Tensioner Control Module -J854- or Right Front Seat Belt Tensioner Control Module -J855-, adapt the components to the Airbag Control Module -J234- using a Vehicle Diagnostic Tester after replacing the seat belt.