Rear Axle Camber, Adjusting
WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.
-- Loosen the nut -4- on the inner spring link -3-.
-- Adjust the camber by rotating the eccentric bolt -2-.
Tip
The maximum adjustment range is 90° to left or right of the center position.
-- Tighten the new nut -4-, at the same time counterhold at the eccentric screw -2-.
-- Check the camber specified value. Refer to Axle Alignment Specified Values .
Tightening Specifications
- Refer to Overview - Spring Link .