Driveshaft, Removing And Installing, Golf From My 2013, Golf Wagon From My 2014, Golf From My 2017 And Golf Wagon From My 2017: Installing

Install in reverse order of removal while noting the following:

-- Install all parts marked to each other in their original positions.

Install the intermediate bearing without tension.

-- Align the intermediate bearing in its oblong holes so the driveshaft or bearing is not under stress.

-- Tighten the intermediate bearing only after the driveshaft has been attached.

-- Tighten the driveshaft and intermediate bearing. Tightening specifications. Refer to OVERVIEW - DRIVESHAFT .

-- Remove the heat shield -1- from the bevel box.

Fig 1: Driveshaft Heat Shield

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Tightening Specification:

• Bolt -A- 20 Nm
• Bolt -B- 40 Nm

-- Tighten the pendulum support with >>new<< bolts. Tightening specifications. Refer to OVERVIEW - SUBFRAME

Fig 2: Identifying Pendulum Support Bolts

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the center tunnel heat shield under the intermediate bearing. Refer to COMPONENT LOCATION OVERVIEW - HEAT SHIELD .

-- Install the exhaust system. Refer to OVERVIEW - MUFFLER .

-- Install the rear tunnel brace. Refer to TUNNEL BRACE, REMOVING AND INSTALLING .

-- Install the noise insulation. Refer to OVERVIEW - NOISE INSULATION .