Lock Carrier, Removing And Installing: Removing

WARNING: This page is about a different car, the 2023 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.

-- Only perform the service position using the Guide Pins:T10093 . Refer to SERVICE POSITION, SETTING AND RESETTING .

-- Together with a second technician, remove the Guide Pins:T10093 on the left and right longitudinal member. Support the lock carrier with the attachments -1-. For example, on the Engine and Gearbox Jack:VAS 6931 .

-- Remove the bumper carrier and support. Refer to OVERVIEW - LOCK CARRIER .

-- Loosen the radiator module from the lock carrier -arrow a-, but do not remove it. Refer to [For engine(s) DSFB] Radiator/Radiator Fan .

-- Lift the condenser -3- out of the radiator module -2- -arrow b- and pivot it slightly out of the lock carrier -arrow c-, but do not remove.

-- Remove the lock carrier -1- between the radiator module and condenser upward -d arrows-.

NOTE:

Never hang the condenser and the hydraulic fluid cooler on the lines.

The condenser and hydraulic lines must not be kinked.